MIL-DTL-62030E(AT)
6.4 Conformance inspection. Affordable conformance inspection with confidence varies
depending upon a number of procurement risk factors. Some of these factors include: Contractor
past performance, Government schedules and budget, product material and design maturity,
manufacturing capital equipment and processes applied, the controlled uniformity of those
processes, labor skill and training, and the uniformity of measuring processes and techniques.
During the solicitation, contracting documents should indicate those tests desired from table IX
and their designated frequency based on a risk assessment for the procurement.
6.5 Brake adjustment. Before or during dynamometer operation, 136 N·m (100 ft-lb)
torque should be applied to the brake shaft. To adjust brake, remove brake inspection cover and
turn adjusting screw until proper indicator alignment is obtained. Each brake should be adjusted
separately (see 4.5.5.2).
6.6 Definitions.
6.6.1 Leakage. The following definitions are established as guidelines governing leakage:
a. Weep - Any evidence of fluid beyond a seal or splitline.
b. Seep - Any evidence of fluid beyond a seal or splitline that does not result in the
formation of a droplet.
c. Leak - Any evidence of fluid beyond a seal or splitline that results in the formation
of a droplet.
d. Drip - Any evidence of fluid beyond a seal or splitline where droplets form and
fall.
6.6.2 Transmission orientation. The terms LH and RH derive from the following
orientation:
a. The "front" of the transmission is the end which mounts next to the engine.
b. The "rear" of the transmission is the end opposite from the front.
c. The "right" side is the side on the viewer's right as he faces the transmission from
the rear.
d. The "left" side is the side on the viewer's left as he faces the transmission from the
rear.
e. These definitions are established relative to the transmission only and not relative
to any vehicle installation definitions.
6.7 Recycled materials. The use of recycled materials, which meet the requirements of
the applicable material specifications without jeopardizing the intended use of the item, will be
encouraged (see 3.2).
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business